This is the trouble with "drawings" instead of actual photographs. They
leave out details that are actually there. No where on this page do I see
ANY reference to TB25D Torque Arms . . .
Stan
w7ni@easystreet.com
----- Original Message -----
From: "Mike Gilmer, N2MG" <n2mg@eham.net>
To: <na9d@speakeasy.net>
Cc: <towertalk@contesting.com>
Sent: Wednesday, September 18, 2002 7:22 PM
Subject: Re: [Towertalk] Rohn 25 Guy Bracket/Torque Arm Question
> Look at the pic in the middle left side for the correct placement.
>
> http://www.rohnnet.com/rohnnet2001/catalog/pdfs/25G/25G-15.pdf
>
> Nice drawing, but what it doesn't show is the "bump" in the guy bracket
> horizontals where they pass over the z-brace at the tower welds (would be
to
> the right in the drawing).
>
> Mike N2MG
>
|