I'm a little confused about how to wire a Polyphaser IS-RCT. If
I'm looking at this correctly there are only 4 terminal positions on
either side of the block. So what does one do when you want to
wire all 7 of your rotor control lines to this unit?? I'm assuming,
and we know what that means, that you only want to wire the 4
control wires of the rotor, i.e. do not wire the ground, the + or -
leads coming from the rotor. I've never had a rotor prior to this so
I'm looking for advice/techinical support on how the Polyphaser IS-
RCT should be wired.
Thank you,
Don Thaxton
N0FGK
|