You don't pull the shied through the 4 holes. You first tin the shield then
install the PL-259. Then you solder the tinned shield through the 4 holes so
that you have a good electrical connection. Without properly soldering the
shield to the connector body, you are asking for all sorts of problems -
intermittents on receive, arcing that causes noise in other receivers.
Use a hot iron or soldering gun. I find my 250/300w gun works great - heats
the connection quickly. I like using silver plated PL-259's. If I use a
nickel plated one, I use a box knife to clean around the 4 holes - it makes
the solder stick easier. Make sure you have good flow of solder between the
shield and the holes. When you take the heat off the connector you should
see the solder suck in a little.
Tony
N2TK
-----Original Message-----
From: towertalk-admin@contesting.com
[mailto:towertalk-admin@contesting.com]On Behalf Of Ronald KA4INM Youvan
Sent: Thursday, May 30, 2002 23:58
To: Tower Talk
Subject: Re: [Towertalk] Re: Coax Connector Losses - Does anyone know?
> Losses for a PL-259/SO-239 combination were measured than 0.01 dB
> up to 50 MHz! When properly installed and weatherproofed, these
> connectors are plenty good at HF.
We haven't mentioned how we solder the shield through the four little
holes. (a friend told me he quit pulling the wires through the little
holes and soldering them to the barrel, he just twists them on and solders
the
center pin, then uses them)
Some folks may think UHF connectors are crap because they never met a gud
one.
A heavy soldering gun like the GT-7 (with the 700 degree tip, or any of
several 200+ Watt Wellers) or a fine tipped torch, (experience needed to use
very quickly) are pretty much necessary to make a secure shield connection.
(sometimes pre tinning the shield is helpful)
I solder through two holes for HF under 100 watts, all 4 for more power
or frequency.
Many times I have overheard QSO's where an OM said: `all I did to clear
up my intermittent problem, was to make all new jumper cables'.
(in the shack)
73 (= Best Regards) de: Ron ka4inm@tampabay.rr.com
100% LINUX, since July, 1997 SENT Time and Date are UTC
Visit my HAM Web SITE at: http://www.qsl.net/ka4inm
_______________________________________________
Towertalk mailing list
Towertalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|