To: | <towertalk@contesting.com> |
---|---|
Subject: | [Towertalk] Re: TB3 Set Screw |
From: | n2mg@eham.net (Mike Gilmer) |
Date: | Thu, 16 May 2002 19:28:43 -0300 |
W7AG wrote: > Is it necessary to secure the TB3 set screw with loctite > before installing the bearing on the mast? It may not be necessary, but probably a good idea - and be sure to use "removable" threadlocker. If you move/remove with that set screw, be sure you have re-installed properly - so there is no binding of the bearings. Mike N2MG |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | [Towertalk] Terrain Analysis, Robert Shohet |
---|---|
Next by Date: | [Towertalk] Lightning Protection - Conclusion (for me, anyway), EUGENE SMAR |
Previous by Thread: | [Towertalk] Terrain Analysis, mwdink@eskimo.com |
Next by Thread: | [Towertalk] Questionnaire, mwdink |
Indexes: | [Date] [Thread] [Top] [All Lists] |