Alton,
I tried unsuccessfully to find this bearing several years ago. Even had my
bad bearing send off to the factory with no luck, they said it was made in
something like 1943. What you might be able to do is to bore out the
bearing race, etc.
Mike W9RE
> -----Original Message-----
> From: towertalk-admin@contesting.com
> [mailto:towertalk-admin@contesting.com]On Behalf Of Alton McConnell
> Sent: Friday, May 10, 2002 11:57 AM
> To: towertalk@contesting.com
> Subject: [Towertalk] Bearing for Prop Pitch Motor
>
>
> Hello Everyone:
>
> I need to locate a bearing for a prop pitch motor. The bearing
> is a MRC G
> 203 R1. MRC has ignored my e-mails. Detroit ball bearing does not have
> one.
>
> This bearing goes on the low speed hub in the large planitary
> gear system.
> There are six bearings on the hub. I have one that is bad.
>
> The bearing is 17 mm id, 10 mm thick (high) and 1.5 inches OD. I am told
> the dimensions are starnge to keep people from using industrial
> bearings in
> aerospace applications.
>
> Does anyone have a source for this bearing or does anyone have a spare
> bearing from a junk PP motor?
>
> Any advice is welcome!
>
>
> Thanks and 73,
>
> Alton, NU8L
> 231-779-6215 or 231-862-3774
> nu8l@arrl.net or amcconnell3@hotmail.com
>
>
>
> _________________________________________________________________
> Chat with friends online, try MSN Messenger: http://messenger.msn.com
>
> _______________________________________________
> Towertalk mailing list
> Towertalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
|