Hi Clive,
On occasions, I've used another Beverage termination technique, albeit more
costly.
I use a transformer similar to the one on the receiver end at the
termination end. Then, I terminate it with a 50 Ohm resistor. 50 Ohm
non-inductive load resistors are readily available.
73,
Joe W1JR
At 02:36 PM 2/10/2002 +0000, Clive GM3POI wrote:
>Has anyone got any views on the suitability or not of using metal film
>resistors to Terminate Beverages. 73 Clive GM3POI
>
>
>________________________________________________________________________
>Where do you get ICE bandpass filters & beverage matching boxes? The
>same place that pays for the hosting of this list: The eHam Store.
>Order online at http://store.eham.net.
>-----------------------------------------------------------------------
>
>-----
>FAQ on WWW: http://www.contesting.com/FAQ/towertalk
>Submissions: towertalk@contesting.com
>Administrative requests: towertalk-REQUEST@contesting.com
>Problems: owner-towertalk@contesting.com
________________________________________________________________________
Where do you get ICE bandpass filters & beverage matching boxes? The
same place that pays for the hosting of this list: The eHam Store.
Order online at http://store.eham.net.
-----------------------------------------------------------------------
-----
FAQ on WWW: http://www.contesting.com/FAQ/towertalk
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
|