Towertalk
[Top] [All Lists]

[TowerTalk] Portable Tower Fabrication?

To: <towertalk@contesting.com>
Subject: [TowerTalk] Portable Tower Fabrication?
From: n9rla@yahoo.com (Dan Evans)
Date: Sat, 15 Dec 2001 04:56:55 -0500
> I have also seen a drive on base plate like you mentioned. I don't
remember
> where I saw it but I do know it was a web site showing a Rover station in
> one of the UHF/VHF contests
> 73
> Rick
> KC5AJX
>
I haven't personally done anything quite as big as was suggested, but I did
build and use a drive on base plate for awhile.  I used it to support about
20' of mast rotor, and vhf antennas in my Rover expeditions.

On The Rover Resource Page, http://www.qsl.net/n9rla   is a collection of
photos from a lot of different Rover stations.   You may be able to get some
ideas from them.

Good luck,
Dan

Dan Evans N9RLA
Scottsburg, IN 47170
{EM78}
IN-Ham list administrator
QRP-l #1269
1/2 of the N9RLA /R no budget Rover Team
Check out the Rover Resource Page at:
http://www.qsl.net/n9rla

----- Original Message -----
From: "Rick Bullon" <kc5ajx@hotmail.com>
To: <n4dd@preferred.com>; <towertalk@contesting.com>
Sent: Saturday, December 15, 2001 3:00 AM
Subject: Re: [TowerTalk] Portable Tower Fabrication?



_________________________________________________________
Do You Yahoo!?
Get your free @yahoo.com address at http://mail.yahoo.com


List Sponsored by AN Wireless:  AN Wireless handles Rohn tower systems,
Trylon Titan towers, coax, hardline and more. Also check out our self
supporting towers up to 100 feet for under $1500!!  http://www.anwireless.com

-----
FAQ on WWW:               http://www.contesting.com/FAQ/towertalk
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com


<Prev in Thread] Current Thread [Next in Thread>