First off I have a old Wilson rotatable crankup.
On the mast, I installed a guy ring type bearing with a horizontal aluminum
tube.
One end supports the middle of my 80 meter dipole. Other end supports
vertical wire for 160.
This way the tower can rotate and the dipole and the vertical 160 wire
remain stationary.
The wire is attached to the tube at 24" from the tower, which was the
dimension in on4un's book.
The wire is approx. 50 feet to the ground.
Braid to tower ground/earth ground/radials.
Center conductor to variable caps. and to wire.
Best I can get using a MFJ is 3 to 1 and it fluctuates with the wind blowing
the wire slightly.
What is the best approach, move the wire closer to the tower or try
more/less caps?
Using the graphs in N4BA old article I should be pretty close on dimensions.
Anyone see any obvious errors?
------------------------------------------------------------
My wife dresses to kill. She cooks the same way.
------------------------------------------------------------
Bill H. in Chicagoland
w9ol@billnjudy.com
List Sponsored by AN Wireless: AN Wireless handles Rohn tower systems,
Trylon Titan towers, coax, hardline and more. Also check out our self
supporting towers up to 100 feet for under $1500!! http://www.anwireless.com
-----
FAQ on WWW: http://www.contesting.com/FAQ/towertalk
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
|