I think Mike is on the right track here. There is a lot of variation in
the
quality of the connectors BUT what is most likely the problem with getting
solder to stick to most of them is contamination.
A good cleaning with flux of alcohol or soap and water or almost anything
would likely greatly improve the sucess you will have with getting the
solder to willingly flow to the connector.
You can bet the machinery that is used in the manufacturer of the
connectors
uses oil and that the inexpensive connector manufacturers don't take the
time(money) to clean them before they send them out.
73, Jim KG0KP
> ----- Original Message -----
> From: "Michael Brown" <k9mi@home.com>
> To: "Eddy Avila" <k6sdw@hotmail.com>; <towertalk@contesting.com>
> Sent: Saturday, October 20, 2001 10:16 PM
> Subject: Re: [TowerTalk] RE: Crappy PL259's
>
>
> >
> > Right or wrong, I use flux from RS on my soldering jobs. Put it on
> > the pl 259, heat it up, clean it off with alcohol and should have no
> > trouble having solder stick to the connector.
> >
> > I just use this on building wire antennas, mic connections and PL 259's.
> > I don't repair radios, and I doubt you would want to use this method
> > on radio components! But for the crude stuff, it works for me.
> >
> > The flux is getting all the oil and crud off so your solder will stick.
> >
> > Mike - K9MI
>
>
>
List Sponsored by AN Wireless: AN Wireless handles Rohn tower systems,
Trylon Titan towers, coax, hardline and more. Also check out our self
supporting towers up to 100 feet for under $1500!! http://www.anwireless.com
-----
FAQ on WWW: http://www.contesting.com/FAQ/towertalk
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
|