Having lots of trouble with my rotator Yaesu G-2700SDX.
1 - After switching on the desk controller, notice aleatory movement of the
needle without touching the controller. Going back anf forth, until it goes
to a position sometimes completely different from the position of the
antenna.
2 - RF affects the controller as when TX needle moves slightly changing its
position.
3 - Checked resistances between the pins of the rotator socket (at the end
of the cable in the shack):
pin 1 - 3 : 518 ohms....1-2 : 290 ohms 2-3...235 ohms but values change
(cable???)
Would like to hear your opinions about this nightmare...and possible
solutions.
Tnx de Luis, CT4NH
begin 666 Luis Sutil Teixeira , CT4NH.vcf
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C#0I2158Z,C P,3$P,#E4,C$P,3$U6@T*14Y$.E9#05)$#0H`
`
end
List Sponsored by AN Wireless: AN Wireless handles Rohn tower systems,
Trylon Titan towers, coax, hardline and more. Also check out our self
supporting towers up to 100 feet for under $1500!! http://www.anwireless.com
-----
FAQ on WWW: http://www.contesting.com/FAQ/towertalk
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
|