Call US Tower and order a TB-2US. I just measured mine and its appears to be
7 1/4 between 5/8 Bolts. Its big and used on all the big US towers. Cost
somewhere around a $100.00 73 Gene K2QWD
-----Original Message-----
From: owner-towertalk@contesting.com
[mailto:owner-towertalk@contesting.com]On Behalf Of Barrie Smith
Sent: Saturday, September 08, 2001 8:51 PM
To: towertalk@contesting.com
Subject: [TowerTalk] Thrust bearing
Hello:
My previous question regarding a thrust bearing for a Telex Hy-Gain HG70-HD
did not yield much response.
Perhaps a better question would be: Where can I get a very heavy-duty
thrust bearing that will accept a 2" mast, and can be bolted to the flat
steel plate at the top of the tower.
Drilling, welding, machining or adapting is no problem. I just need the
bearing and bearing holder.
The reason I need "very heavy duty" is because I'll have a 26' X 27'
H-frame, four relatively large 6M beams, and an elevation rotor on the mast
above the tower.
Thank you,
Barrie, W7ALW, Missoula, Montana
List Sponsored by AN Wireless: AN Wireless handles Rohn tower systems,
Trylon Titan towers, coax, hardline and more. Also check out our self
supporting towers up to 96 feet for under $1500!! http://www.anwireless.com
-----
FAQ on WWW: http://www.contesting.com/FAQ/towertalk
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
List Sponsored by AN Wireless: AN Wireless handles Rohn tower systems,
Trylon Titan towers, coax, hardline and more. Also check out our self
supporting towers up to 96 feet for under $1500!! http://www.anwireless.com
-----
FAQ on WWW: http://www.contesting.com/FAQ/towertalk
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
|