Tom:
Another material you may want to consider is PVC. I use 10 ft
sections of 1 1/2 inch PVC pipe. I cut a slit in the top, with a hack
saw, about 3 inches deep, and wedge the wire in the slit. At the
bottom, I use a short piece rebar scrap (~2 ft long) pushed (by
hand or sledge hammer, depending on how soft the ground is at
the time) 1/2 way into the ground, then I put the PVC pipe over it.
My Beverages are up only from October to April, as one goes
across a farmed field, and it's very quick and easy this way to
install and remove them. I've been using the same rebar and PVC
pipe for almost 10 years, with no degradation, and the supports
have withstood big winds, snowstorms, etc. without a problem.
73,
Barry W2UP
On 26 Jul 01, at 8:58, Tom Rauch wrote:
>
> I'm planning on using pressure treated 2x4's to support some
> Beverages. I'll just poke some holes in the ground with my tractor's
> post hole digger attachment, and drop the 2x4's in.
>
> Does anyone have any tips on making the wood last longer, or will it
> be OK in direct contact with soil?? Will it last ten years or so? 73,
> Tom W8JI W8JI@contesting.com
>
>
> -----
> FAQ on WWW: http://www.contesting.com/FAQ/towertalk
> Submissions: towertalk@contesting.com Administrative
> requests: towertalk-REQUEST@contesting.com Problems:
> owner-towertalk@contesting.com
>
--
Barry Kutner, W2UP Internet: w2up@mindspring.com
Newtown, PA Frankford Radio Club
-----
FAQ on WWW: http://www.contesting.com/FAQ/towertalk
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
|