Towertalk
[Top] [All Lists]

[TowerTalk] Removing rivets?

To: <towertalk@contesting.com>
Subject: [TowerTalk] Removing rivets?
From: k1ttt@berkshire.net (David Robbins)
Date: Sat, 07 Jul 2001 16:55:41 +0100
if the rivets are tight you can use a drill bit just a bit larger than the hole
in the rivet.  most pop rivets take about a 1/8" hole, i use a 3/16" or so bit
and drill just until the head comes off, don't push hard and stop quickly or you
will enlarge the orginal hole.  when the head is off you can use a small awl or
nail set to push out the back side of the rivet.  

if they are loose in the hole you can use a small dremel(sp?) tool or a file to
grind the head off.

if they are really loose ones and are aluminum you can often get a pair of side
cutting wire cutters under them and just snip the heads off.


Barry Kutner wrote:
> 
> Looking for advice on how to remove rivets. New territory for me...
> Tnx,
> Barry

-- 
David Robbins K1TTT
e-mail: mailto://k1ttt@berkshire.net
web: http://www.k1ttt.net
AR-Cluster node: 145.69MHz or telnet://k1ttt.net

List Sponsor: Are you thinking about installing a tower this summer? Call us
for information on our fabulous Trylon Titan self-supporting towers - up to
96-feet for less than $2000! at 888-833-3104 <A 
HREF="http://www.ChampionRadio.com";>
www.ChampionRadio.com</A>

-----
FAQ on WWW:               http://www.contesting.com/FAQ/towertalk
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com


<Prev in Thread] Current Thread [Next in Thread>