At 10:11 PM 6/6/01 -0500, Jim Rhodes wrote:
>Has anyone out there ever used the rohn 24' fiberglass insulators? If they
>aren't too expensive (yes I know they are sold by rohn) they look like a
>good way to get the EHS guys away from the tower. Would be great on my
>stubby thing, the guys on it now are just EHS with no insulators and they
>to mess up the wires.
I'm not familiar with Rohn's, but I have 3 21-foot Joslyn versions on my
Rohn 25. They are really easy to work with, because they have a
clevis-type pin on each end that fit perfectly through the Rohn torque bar
holes. On the down-guy end I just used a thimble/grip combination to
convert to EHS. They cost about $50 each new, from US Tower Service in
Frederick, MD. The Joslyns may be cheaper because I believe they are
designed for power-pole use. They are very light but are rated at
something like 15K pounds breaking strength
The one trick with these things is getting them home -- they are semi
rigid, and draped over my pickup truck rather artistically with only a
little bit sticking out front and back.
73, Pete N4ZR
No, no ... that's WEST Virginia
List Sponsor: Are you thinking about installing a tower this summer? Call us
for information on our fabulous Trylon Titan self-supporting towers - up to
96-feet for less than $2000! at 888-833-3104 <A
HREF="http://www.ChampionRadio.com">
www.ChampionRadio.com</A>
-----
FAQ on WWW: http://www.contesting.com/FAQ/towertalk
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
|