Towertalk
[Top] [All Lists]

[TowerTalk] Quad Question(s)

To: <towertalk@contesting.com>
Subject: [TowerTalk] Quad Question(s)
From: K3BU@aol.com (K3BU@aol.com)
Date: Wed, 2 May 2001 19:39:58 EDT
In a message dated 5/2/01 12:30:20 PM Eastern Daylight Time, 
w8ji@contesting.com writes:

>  
>  I'd bet almost zero quad wires fail from exceeding tension limits of 
>  the wires, and most fail from flexing at joints.
>  

I will take the bet!
I never had wire fail in Quad from flexing. There is (almost) no flexing when 
antenna is properly strung, with just enough tension to keep the wires from 
flopping or flexing. In the corners I use black plastic ties, wrap it around 
the wire couple of times and thread it through the hose clamp, which clamps 
to the spreader. I keep about half inch distance between wire and hose clamp 
to prevent any potential arcing over at high voltage point (due to 
capacitance). When the spreaders and wire are up, I keep pulling one corner 
to get the proper tension, just enough not to bend the spreaders and make 
wire nice and tight.

I wouldn't use aluminum wire, copper is cheap and good.
Wire I use is #12 or #10 house PVC coated solid Cu wire. I pre-stretch it 
(harden) and it doesn't go anywhere after that. Originally I though that 
insulated wire would minimize the rain static, but the difference is hardly 
noticeable. Insulation only prevents corrosion and wire has to be shortened 
by about 4% due to lengthening by insulation. 

Properly designed and installed quad will provide trouble free service and 
run circles around Yagis (up to 4 elements). You can have quieter reception 
and dual polarization with one feed line. 
That ain't no folklore, it is a proven, measured fact (not just calculated).


Yuri, K3BU

List Sponsor:  ChampionRadio.com - Trylon self-supporting towers,
safety equipment, rigging gear, LOOS tension guages & more!
http://www.championradio.com

-----
FAQ on WWW:               http://www.contesting.com/FAQ/towertalk
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com


<Prev in Thread] Current Thread [Next in Thread>