Howdy, TowerTalkians --
Recently we were discussing something other than connectors. The subject
was proper bolt/nut torque for a Trylon tower. Here is the factory info. You
could probably apply it to just about any bolt/nut that size.
>All tower bolts must be properly tightened. Recommended torque values
> are as follows:
>* 1/4" 6 ft. lbs.
>* 5/16" 11 ft. lbs.
>* 3/8" 17 ft. lbs.
> Bolt hardware supplied with split washers should be installed by "turn
> of the nut method" -- snug plus 1/4" to 1/2" turn. It is extremely
> important not to over tighten bolts. Excessive tightening will reduce the
> locking ability of the bolt assembly.
Cheers, Steve K7LXC
Tower Tech
Champion Radio Products
|