Towertalk
[Top] [All Lists]

[TowerTalk] SDS Pin driver attachment for hammer-drill

To: <towertalk@contesting.com>
Subject: [TowerTalk] SDS Pin driver attachment for hammer-drill
From: billwall@bellsouth.net (Bill Wall)
Date: Wed, 22 Dec 1999 08:02:14 -0500
Hi everyone and a very good holiday season to you.
There is an electric impact hammer that is being rented at tool rental
companies in the Atlanta area. A good friend of mine N4SE Mac  is a
salesman at Northside tool. I rented this hammer and drove 4 two piece
Ga. power grounds into my granite filled soil in about 6 hrs. The rods
are 8' long and use threaded couplings. Total rental cost was less than
$50.00.
I hope this helps,
                                               Bill Wall  KC4UZ
                                                Quads are better

Bert wrote:

> Hi all,
>
> I was looking at some SDS bit hammer drills and am curious,
> is there a attachment available for driving ground rods with a SDS
> type drill ?  Bosch makes a 1" tri-mode model for under $250,
> and that is a attractive compared to spline type models.
>
> Thanks, Bert - K4AR
>
> --
> FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
> Submissions:              towertalk@contesting.com
> Administrative requests:  towertalk-REQUEST@contesting.com
> Problems:                 owner-towertalk@contesting.com
> Search:                   http://www.contesting.com/km9p/search.htm


--
FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>