This post is on behalf of Ralph, N4CQC who has a 60 ft. tower that originally
was part of a 200 ft. broadcast tower. Triangular tower, face dimension
approximately 16 inches and much heavier than Rohn 25. He has 3 sections that
are 20 ft. long each along with a thrust bearing for a 2 inch diameter mast. It
is on the ground and will require a flat bed truck for transport. Located in
Kensington, NH (Southeast NH) this is local deal only. The base section has a
tiltover mechanism. Tower is assembled on the ground, then is pulled up to the
final position by tractor or other. Guy wire included.
Looking for $300 or best offer. Call 603-772-8639 after 6 PM EDT.
Regards,
Mark, K1RX
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|