Hi everyone: I knew here, I don't know how I missed this reflector but I
did but not any more.
I have a 100 Ft. SSV tower sitting in 16 Yards of concrete. I have a (I
believe been awhile) 2 in. ISD gas pipe for a center mast with I think 3/8
wall thickness. Anyway I have 5-6 ft. in the tower on a tailtwister
rotator. The mast is in a thrust bearing so there isn't any weight on the
rotator. at about a foot above the tower is a TH-6DXX Tribander, about 3
Ft. above that is a pair of Rutland arrays one being horzonital, other
being vertical, above that is another pair of Rutland 2 meter same setup,
both of the arrays are on about a 12 ft. boom horzonital from each other.
On top are two verticals for 432 & 2.
I am going to remove the top verticals and replace it with a diamond 6,2,70
cm antenna.
I also just bought a 6 meter beam M2 5 element which I want to mount at the
top of the mast. Top of the mast is about 15 ft. above the tower.
Should I replace the mast with a larger one or can I just insert another
mast inside the present one and bolt through ?
I am concerned with bending the mast over in high winds and particulary now
that I would be mounting the 6 M beam at the top of the mast so that I can
get the proper spacing.
Comments and Idea's please Thanks
Ron WA9PAM
ronald@marcus-online.net
http://webpages.marcus-online.net/ronald/
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|