Towertalk
[Top] [All Lists]

[TowerTalk] 40M Beam Interaction

To: <towertalk@contesting.com>
Subject: [TowerTalk] 40M Beam Interaction
From: Brian.Harris@sv.sc.philips.com (Brian Harris)
Date: Wed, 2 Jun 1999 14:04:03 -0700
Gale,

My XM-240 is 10' above and parallel with my TH6.  The SWR of the TH6 was not 
effected much on 20 and 10 meters (compared to measured values when it was 
pointed straight up).  15 meters is another story.  While the SWR was at a 
minimum at about 21.20 (when pointed up), 20.9 is where the current minimum is. 

Unfortunately both antennas were installed at the same time so I have no easy 
way of comparing other parametric changes.

Brian


______________________________ Reply Separator _________________________________
Subject: [TowerTalk] 40M Beam Interaction
Author:  GALE STEWARD <k3nd@yahoo.com> at !SMTP/INTERNET
To: <towertalk@contesting.com>
Date:    6/2/99 9:48 AM




I have heard that the "new" Cushcraft, 2 el 40M beam (XM240)  has
substantial interaction with nearby 20 M, full size, elements.  I
understand that the older 40-2CD doesn't exhibit this tendency!  Anyone
have any practical experience with these antennas stacked 9 - 12 with a
20 M beam?  Any info appreciated!

73, Stew  K3ND, Trustee W3KLG 

_________________________________________________________
Do You Yahoo!?
Get your free @yahoo.com address at http://mail.yahoo.com


--
FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


--
FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>