Towertalk
[Top] [All Lists]

[TowerTalk] Problems with YAESU Rotor

To: <towertalk@contesting.com>
Subject: [TowerTalk] Problems with YAESU Rotor
From: kb0pyo@rconnect.com (Mark Brown)
Date: Sun, 14 Feb 1999 22:57:41 -0600
Hi All Again
        Just replaced the 2 resistors in the control box of the
g800 AGAIN, this time with 120 ohm 2 watters, if they go I
am going to chuck this piece of s__t out the door & put up
the ham 4.
                Mark
ps:the last set of 120ohm 1 watters lasted less than 2
weeks, Yaesu claims their aren't any problems with the
design of the g800s control box, the first set of resistors
died at 3 months (they supplied replacements) the second at
13 months (send it in we will fix it for around $100), this
is now the 6th pair of resistors & the control board has
burnt through so bad that I have had to replace traces with
wire! The g800s control box is JUNK!!!

Douglas Bradford wrote:
> 
> Andy Wallace wrote:
> >
> > Steve--
> >
> > The clutch would only let loose in dangerously high winds. I'd rather 
> > replace a
> > coax connection then worry with a tower twisted down--I think it would be a
> > little cheaper.
> >
> > Andy   K5VM
> 
> If the wind is high enough to twist the Tower, I would think everything
> else would be gone. You are speaking of Tornado type wind.
> 
> 73  Brad  KZ5Q
> 
> --
> FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
> Submissions:              towertalk@contesting.com
> Administrative requests:  towertalk-REQUEST@contesting.com
> Problems:                 owner-towertalk@contesting.com
> Search:                   http://www.contesting.com/km9p/search.htm

--
FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>