In a message dated 99-02-09 15:57:40 EST, kg8co@lni.net writes:
<< The question is abt guy wire "What size to use"
I see Rohn models Rohn 25 and 45 with 3/16" and 1/4" guy cable.
My plans.....
100' Rohn 45 with 4 element KLM 40 using 4 sets of guys
100' Rohn 25 with 4 element 30 fullsize using 4 sets of guys
100' Rohn 25 with 2 element 10-20 quad using 4 sets of guys
Is 3/16" ok or should I use 1/4" ? >>
The first thing you need to do is to determine what the windspeed rating
for your county is. Go to http://www.championradio.com and look it up. In your
case, Lewanee County, MI, is a 75 MPH windspeed zone.
Next, get the Rohn catalog and look up the tower and the appropriate
height for the windspeed. (Hint: the Rohn catalog is available at the same web
site.)
This will tell you what the proper guy wire size is. You can use
slightly bigger guy wire (1/4 instead of 3/16) but you'll never go wrong by
observing the LXC Prime Directive: "DO what the manufacturer says".
Another hint: be sure to tension it correctly.
A WEALTH of information on this and other topics is in the TowerTalk
archives at www.contesting.com.
Be sure you use EHS (extra high strength) cable (see LXC Prime
Directive above).
Cheers and GL, Steve K7LXC
Champion Radio Products
Tower Tech
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|