Posts on TOWERTALK have made it well known that
the HDBX towers are "rated" for a 10 foot boom, maximum.
Unfortunately, this is a very misleading type of rating since
NOTHING has been stated about the ELEMENTS.
There is a BIG difference in torque from a 2L20 or a 2L
tribander on a 10 ft boom and a multi element VHF antenna
on a ten foot boom. I would expect that a 2M beam on a
30 ft boom would be no problem for this tower, assuming that
it could handle a 32 ft long 20M DIPOLE with NO boom.
A better specification for the tower would be TORQUE, or
an antenna parameter that contributes more directly to
calculating torque, such as surface area and offset from
the mast. In addition, boom length and mass are also
factors to consider when stopping and starting rotation.
To reduce the torque applied to the tower when stopping
rotation, it is best to let the antenna COAST to a stop, rather
than releasing the rotor brake while the antenna is still
moving.
Placing the rotor further down in the tower, in a wider
section, will also lessen the torque load on the tower.
A rotor at ground level with a continuous mast rising
through the full tower height will eliminate torque as
a consideration in the tower load.
de Tom N4KG
___________________________________________________________________
You don't need to buy Internet access to use free Internet e-mail.
Get completely free e-mail from Juno at http://www.juno.com/getjuno.html
or call Juno at (800) 654-JUNO [654-5866]
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|