Tom,
I had my guy rings made at a local machine shop. They took flat stock
and formed an inner angle ring and then an outer angle ring. The ends
were welded together to close the rings. I mounted wp bearings inside
them. I then welded guy loops to the outer ring and leg brackets to the
inner. I installed the assembly on my 72'x18" Heights, aluminum tower.
The tower swings a Mosely S402 at the top and a CL36, 24' below. The
top guy ring is just below the CL36. It's been working perfectly for
years. Will be glad to share any further info if you need.
73,
Ray, W4BYG
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|