This message came with a " the sender has requested a return notification
that you have recieved this meassage". This request is not a good idea on
a mail- list (reflector).
You may not have known that your mail program was set to do this. I have
heard that MS has set this as the default option. If so, that gives
another reason to hope they do better in the future. Hope, but not expect.
Bill-W4BSG
At 07:33 PM 12/21/1998 -0500, you wrote:
>
>
>Presently I have a 4 square based on the article in section 6.3 of ON4UN's
>Low Band Dxing, 2nd edition.
>I have 4 posts with a vertical wire from each pulled up to the top of the
>80' tower. I am using 1/4 wave 70 ohm feedlines to the Comtek box. I have
>one radial on each leg pointing away from the tower. There is a current
>balun at each feed point.
-
Bill Aycock --- Persimmon Hill
Woodville, Alabama, US 35776
(in the N.E. corner of the State)
W4BSG -- Grid EM64vr
baycock@HiWAAY.net
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|