At 05:50 PM 12/2/98 GMT, you wrote:
>
>
>Scott, have you measured the self-resonant frequency of your tower
>with beams on top? If it's anywhere close to 1.8, it will drastically
>affect the feedpoint of the L as you show it.
>
>Without knowing the tower's self-resonant frequency, it's going to be
>very hard to anticipate the feedpoint Z of the L. You may want to
>consider just loading the tower with one of the wire gamma match
>arrangements to be found in the various antenna books. Given the
>tower's thickness, and all the beams on top, you may not need the L
>for anything.
>
>I would estimate you couldn't put an L anywhere on your property
>without the tower modifying the L impedance and/or pattern.
>
>73, Guy
Guys has a good idea Scott. Goe up your tower about 3/4 of the way and
hank out metal arm....3 to 5 feet out from the tower. Attach #12 wire
(Make a good electrical connection) and drop it down the tower. Drive a
stake into the dirt about 3 to 5 feet out...and use a capacitor to feet it.
Shield goes to the ground and radials. You just gamma matched your tower.
If you can;t get it matched, then use an Oemga match, but it will be
sharper in resonance. Instead of #12 or #10 wire, use a hunk of old coax
as the gamma match wire and use the braid as the wire. Gives you a little
more bandwidth on 160 by using a thicker wire. At least that has been my
experience. I've done this with a 50 foot tower and a TH6 and works FB.
Used a 365 pf broadcvast variable for 100 watts and had a ball. Remember
the beam on the top acts a a capacitor hat.
Lee
k0wa@southwind.net
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|