Speaking of recurring threads, let me dust off this
oldie but goodie.
A good thing to do every year or so is to measure your
feedline losses. If you have an antenna analyzer that reads
high values of swr with reasonable accuracy, the measurement
can be done from the comfort of your radio room, without
disconnecting the antenna.
Attach the analyzer to the feedline in question, with the antenna
still connected. Tune the analyzer's frequency until you see the
highest peak in indicated swr on the meter. There will usually
be several high peaks. Pick the highest one near the high end of
the analyzer's range.
Plug the peak observed swr into the following equation:
LOSS = 10LOG((SWR+1)/(SWR-1))
For example, if you see a peak swr of 8 at 24 mhz
LOSS = 10LOG(9/7) = 1.09 dB at 24 MHz
Then all you have to do is consult a coax loss chart to see if
the measured loss is reasonable for the type and length of
coax being used, and whether it would be cost effective to put up
new/different coax.
The reason this method works is that almost all antennas present
a high value of impedance when operated outside their design
range. This high impedance is a close approximation of an open
circuit, and the equation above is valid. This idea was
presented in QST a few years ago, but the author presented a
graphical, rather than mathematical, solution. I like the mathematical
solution better, because you don't have to go back and dig up the QST
article.
Some people distrust the accuracy of high value swr readings
obtained on inexpensive analyzers, and prefer to take
repeated measurements over several years to detect trends,
rather than believing the absolute numbers. That's ok too.
Whenever I have used the above method to measure brand-new coax,
the results have always agreed closely with expected losses.
Dave Hachadorian, K6LL
Yuma, AZ
K6LL@juno.com
___________________________________________________________________
You don't need to buy Internet access to use free Internet e-mail.
Get completely free e-mail from Juno at http://www.juno.com/getjuno.html
or call Juno at (800) 654-JUNO [654-5866]
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|