Hi,
I seem to recall a piece of trivia in an '80s QST that explained the
designation of connectors.
"N" and "C" connectors (remember them?) had as their letters the initial of
their designer's surname. I think that BNCs and TNCs were joint efforts
(Bayonet and Thread) between "Mr N" and "Mr C".
This sounds very twee and unlikely, but it's stuck in my mind.
Maybe some TowerTalkian can set the record straight.
73
Al, GM4BAP
BTW, I've noticed 7/16 EIA is being increasingly promoted as THE connector
for use with LMR-400/600 and Heliax. Prices are broadly similar to N-types.
Does anyone have comparative data and/or comments?
------------------
> In fact, I have heard somewhere that BNC stands for "Bayonet N
> Connector". The BNC and TNC are non-weather sealed versions of
> the basic type N (I think this originally referred to "Navy")
> controlled impedance guts. Either the BNC or TNC female can in
> fact (but shouldn't be) mated to an N male (of similar intended
> impedance) and function correctly for RF purposes.
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|