Hi,
I just acquired from an estate, a 60' Crank-up/tilt-over tower
(3-sections) & (it tilts over at the base).
I did not get any mfg. info with this animal.
It is a 3 sided tower, measuring 13 5/8" from outside of leg to
outside of other leg (face), and approximately 18 7/8" center to
center of the rungs. It does not have any vertical cross-bracing
such as used by Rohn and other manufactures. It also has a 3" pipe
with a winch and pulley acting as a lifting device. This setup
look very similar to that of US Tower, but doesn't have the cross
bracing.
Wonder if anyone out there may be familiar with this animal? Maybe you
have the assembly manual... would pay for copying and such.
BTW it was supporting a TH6DXX before I acquired it.
de Howard W3CQH
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search
|