>With regard to the "unknown" mast thickness, it's a relative
simple
>trick to drill a very small hole
>(about 7/16 is right ) through one wall of the mast, and then
fashion a
>small "L" shaped hook.
>
>Put the short part of the "L" through the hold, bring the long
part
>horizontal, and then put a little
>dab of magic marker flush with the mast.
>
>Remove the hook, and measure the distance.
>
>73
>
>Ed
>
Neat trick, Ed.
I think I can do something similar without drilling a hole.
Bend a wire. Hook it under the bottom end of the mast in the
rotor. Pull it taut. Bend it against the outside wall.
Withdraw it. The distance between bends should be the wall
thickness, shouldn't it?
Thanks for the clue, though. I'll try it at the top when we get
up there with the bucket to take down the A3S.
73,
dale, kg5u
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search
|