Shane Autrey NC4SA wrote:
>
> Now that i have the wiring diagram for the rotor what do i need to do so
> that the control box itself will recognise the direction the motor is
> pointing in. The Ham M control box reads the direction correctly but when i
> wire up the Ham II control box the exact same way the control box gives
Sorry about that last post. After re-reading you message, I see that
you do have the diagram . Take the HAM II box apart and start checking
with the VOM is still my best suggestion and the place I would start
would be with the Cal switch. Particularly if you can make the meter
change reading slightly by varying the cal pot.
Good luck and 73,
--
Ken K4XL
grimm@lynchburg.net
Boatanchor Manual Archive - ftp://198.28.36.115/pub
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search
|