Towertalk
[Top] [All Lists]

[TowerTalk] Rohn 25

To: <towertalk@contesting.com>
Subject: [TowerTalk] Rohn 25
From: w7ni@teleport.com (Stan Griffiths)
Date: Wed, 25 Mar 1998 15:34:42 -0800 (PST)
> With all the discussion about Rohn 25 and windloading etc. You have 
>almost convinced me that trying to fold over my Rohn 25 tower not only 
>isn't going to work but that the tower is only good for uhf vhf 
>antennas!!! 
>  Well I guess the TH6 is going to stay in the barn for another 3 or 4 
>years and I get to keep using my Butternut vertical for my only antenna. 
>It is ashame too as I have 5 empty acres and all I can do is a lousy 
>vertical makes me lose all incentive to upgrade
>  Not flaming anyone just upset that I can't do anything better that 
>what I have. It wouldn't be so bad if I lived on a small city lot
>73
>Rick
>kc5ajx  (tech plus forever)

Hi Rick,

I have had 102 feet of Rohn 25 successfully installed since 1973 with the
following antennas on it:  At 112 feet:  5 element 10 with 20 foot boom.  At
102 feet:  6 element 15 with  32 foot boom.  These two antennas are rotated
together with a Tailtwister.  At 70 feet:  4 element 10 with a 12 foot boom
fixed on the SE.  At 55 feet: 4 element 10 on a 12 foot boom.  At 50 feet:
4 element 15 with a 20 foot boom.  These two antennas rotate together on a
homebrew sidemount for about 300 degrees.  This tower also supports one end
of an 80 meter wire sloper and one end of a 160 meter wire sloper both tied
to the top of the tower.  It also has a two meter ground plane at about 60
feet and a commercial pager antenna at 90 feet (a 2 inch diameter vertical
about 8 feet high and offset from the tower about 18 inches).

The tower is set solidly in concrete and guy wires (four sets guyed three
directions) do all the work.  I used very good earth anchors purchased from
a utilty supply company set 6 feet below the surface and I use 3/16
galvanized wire rope (4200 pounds breaking strength), 1/4" forged
turnbuckles, 500D strain insulators every 20 feet in each guy, and mostly
crimp on copper sleeves as cable clamps except in a few places where I use
conventional wire rope clips.  The thing looks as solid as the day I put it
up.  I would hesitate to put any more stuff on it but I have no problem
climbing to the top to work on the antennas.

For those who will tell me it is overloaded, it probably is, but I put it up
long before I was smart enough to know that and its peformance history tells
me it probably will not fall down at this stage in its life.  I feel safe
with it.

Stan  w7ni@teleport.com


--
FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com
Search:                   http://www.contesting.com/km9p/search

<Prev in Thread] Current Thread [Next in Thread>