Travis Roach wrote:
>
> I like your idea of Gondor the Condor, but am having problems visualizing
> how the V-belt pulleys are connected to the UniStrut. What size are the
> pulleys and how far above the UniStut is the lowest point of the pulleys?
>
> I getting ready to replace my old beam with a new one and would like to
> build a Gondor.
>
> Thanks
>
> Travis Roach K4VVM (ex WA4DOR)
>
> 5993 Bridle Path
> Bartlett, TN 38134
>
> Home (901) 382-4981 Work (901) 386-4070 Fax (901) 388-1170
> Email troach@socomm.net or k4vvm@juno.com
>
The pulleys actually extend down into the U of the unistrut and almost
touch the bottom so the trolley cable is captivated and cannot jump out
of the v groove. To hold the pulleys in place I drilled holes in some
1-1/2 x 1/4 inch strap for bolts to serve as axles, then carefully
aligned the pulley with the bottom of the Unitstrut and welded the
straps in place. Used washers on the bolts to keep the pulleys centered.
Very low tech design and assembly but it works.
\_/ <--------- v Pulley
|
---|-----|--- <- Axle bolt
| | | <-------Strap
||/-\||
|___| <--------UniStrut
Hope this ^ comes out - use Courier font.
de n0yvy steve
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search
|