Since my antenna site is 250 feet down a hill from the shack, I put together
a setup whereby I can send commands from a battery-driven portable packet
station (HT, Baycom TNC, HP 100LX palmtop) to my shack computer. The
computer then issues commands to the rig (TS950SDX) or the amp (Alpha 87A).
I can turn the carrier on and off, select any frequency, low or high power,
send CW from the built-in memory keyer, etc. I haven't done it yet, but I
could set it up to have the amp report the forward and reflected power it
sees.
It's a nice troubleshooting tool, but requires care to use (like staying
away from the antennas while TX is on and making sure to select frequencies
and power levels appropriate to the antenna under test.)
73, Dick, WC1M
-----Original Message-----
From: Edward W. Sleight . <k4sb@worldnet.att.net>
To: Rolfe.Tessem. <rolfe@ldp.com>; towertalk@contesting.com
<towertalk@contesting.com>
Subject: Re: [TowerTalk] Radio Shack remote-reading wattmeter
>Rolfe, the next time you want to key the rig from the shack while up
>the tower or so forth,
>place your rigs' mike near the speaker of your two meter radio. Set for
>VOX, and then use
>a handheld from the tower and key a tone...Tone will be received in the
>shack which will
>turn on the rig and give you output....if you use FM or AM, set it at a
>real low level and let
>the amp do the work....Works great for adjusting antennas right at the
>source.
>
>73
>
>Ed
>
>
>
>--
>FAQ on WWW: http://www.contesting.com/towertalkfaq.html
>Submissions: towertalk@contesting.com
>Administrative requests: towertalk-REQUEST@contesting.com
>Problems: owner-towertalk@contesting.com
>Search: http://www.contesting.com/km9p/search
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search
|