Towertalk
[Top] [All Lists]

[TowerTalk] Re: [TowerTTalk] Where to get thrust bearing?

To: <towertalk@contesting.com>
Subject: [TowerTalk] Re: [TowerTTalk] Where to get thrust bearing?
From: mashaum@fcg.net (Mark Shaum)
Date: Fri, 18 Jul 1997 02:46:55 -0500
> 
> If you want to put the thrust bearing any place on 25G
tower other than on a
> flat plate on the very top, there is no ready-made shelf
for that, that I am
> aware of.  You can always drill a rotator shelf with the
correct hole
> pattern for the thrust bearing you want to use, but you
may still have a
> problem installing it since Rohn rotator shelves will
only go into a 25G
> section where there are no diagonal braces and this is
where you generally
> have to install your rotator.
> 

Rohn's TB3 thrust bearing sits nicely on the AS25G
accessory shelf.  Mine is mounted near the top of a 25AG2
'pointy top' top section, with room for the rotor on
another shelf below.

----------------------------------------
Mark Shaum  K9TR
mashaum@fcg.net
Central Illinois Grid EN50
---------------------------------------


--
FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com
Search:                   http://www.contesting.com/km9p/search

<Prev in Thread] Current Thread [Next in Thread>
  • [TowerTalk] Re: [TowerTTalk] Where to get thrust bearing?, Mark Shaum <=