On 3/26/97 18:59, C. Logan Dietz at ke5fi@wt.net wrote:
>stan@ccsnet.com wrote:
>>
>> Just make sure you use pop rivets with an aluminum center pin. The steel
>> center pins will corrode out in a hurry when outsdie in the weather...
>>
>The center pin comes out when you "pop" the rivet leaving only aluminum
>with a hole in it.
Depends on the type of rivet. Some are designed to leave a solid center
section.
Frankly, if the riven leaves a tube that isn't filled, then it will
eventually fail when subject to tension/compression cycles.
The best type of pull rivets to use are those designed for aircraft use.
The Murphy Aircraft company sells homebuilt aircraft kits that are built
completely with Avdel Avex blind rivets. Highly recommended.
Bill Coleman, AA4LR, PP-ASEL Mail: aa4lr@radio.org
Quote: "Not in a thousand years will man ever fly!"
-- Wilbur Wright, 1901
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
|