In a message dated 97-03-20 17:47:36 EST, n3huv@juno.com (Glenn A
Biggerstaff) writes:
> Then you
> take an empty 38 pistol shell and punch out the primer with a small punch
> and solder it to the inner conductor . Take a 3/8 inch piece of #12 or
> #14 solid copper wire and put it in the hole where the primer came out
> and solder it in place. Then solder a SO 239 panel mount connector to
> the wire in the pistol shell.
This technique recommended for 'big guns' only.
73, Steve K7LXC
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Sponsored by: Akorn Access, Inc. & N4VJ / K4AAA
|