I want to thank all you guys who responded to my previous post on my HD going
bad. Well,
thanks to your remarks ( and a special kudos to Scotty ) I bought another of
the same type,
changed the circuit board from the good one to the bad one, and it took off
like a bandit.
Got all my data off ( and you can bet your ass there's a backup not two hours
old ) and
reinstalled boards. It's so easy to do you could probably do it
blindfolded...take off 5
screws and the cb lifts right off....there's about a 20 pin or so connector
which mates
the two with the male pins sticking up from the sealed unit. That's it...When
reinstalling
the board actually aligns itself with the pins...
Couple of comments....
Seagate told me they do not sell parts, nor do they repair HDs. So what I'm
going to get
is a new one when I ship it tomorrow. They also told me the method some of you
suggested
would not work because the cb had the old drive info ( fat? ) in one of the cb
chips...
that slowed me down until I said, "whoa"...the FATs on the disks...it might
read the FAT
into a chip, but no way is it permanently stored there... Seagate will not sell
parts...
Trouble on the cb was one blown chip....
Which is why today, I ordered 2 Western Digitals. They may not be any better,
but they
can't be any worse. ( he said )
Tnx again guys
Ed ( master HD technologist )
-------------------------------------
Name: Ed Sleight
E-mail: k4sb@avana.net
To: <towertalk@contesting.com>
Date: 1/28/97
Time: 2:16:39 AM
-------------------------------------
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: K7LXC@contesting.com
Sponsored by Akorn Access, Inc & N4VJ / K4AAA
|