I just received my new Beverage Box via Fed Ex. I'm hooking it up tomorrow!
I'm using it with an Icom 751A, which has a receive antenna jumper on the
back for using a seperate receiver or putting in a pre-amp. According to
the schematic the receive side of the jack is not relay switched, but runs
straight to a mute circuit and then to a rf amp.
Am I courting disaster?
I was thinking of grounding the receive side through the amp switching relay
on the rig. It is a reed relay which of course goes to ground on transmit.
I would appreciate any further ideas, or affirmations that I'm heading in
the right direction.
73
Jay WC7M in Gillette, Wyoming
On the 1AB Ranch in Campbell County
--
FAQ on WWW: http://www.contesting.com/topband.html
Submissions: topband@contesting.com
Administrative requests: topband-REQUEST@contesting.com
Sponsored by Akorn Access, Inc & KM9P
--=====================_864140661==_
Content-Type: text/plain; charset="us-ascii"
Mike Bragassa, K5UO
Conroe, Texas: k5uo@contesting.com
Moscow, Russia: bragassa@glasnet.ru
--=====================_864140661==_--
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
|