I broke off a bolt in a Rohn TB3 thrust bearing. It broke off even with the
edge of the flange on the bearing. Is there a good way to get this out while
it's up on the tower, or am I going to be forced to take it down to replace
the bolt?
I'd appreciate any suggestions...
BTW - what size bolts are they anyway? I need to replace all of them because
the ones Rohn supplies are not galvanized or stainless, and they rust
quickly...
Thanks - Will
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: K7LXC@contesting.com
Sponsored by Akorn Access, Inc & KM9P
|