What is the correct size set bolt to use through the mast clamp on a HAM M
type rotator?
I use 1/4" on the Ham III, but that seems to be too big for the Ham M. Is it
3/16" or some oddball size??
BTW - I must put in a good word for CATS, who just rebuilt this 25 year old
rotator for me, and it looks and works like new. All for $50 - can't beat
that!!
73,
Will
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: K7LXC@contesting.com
Sponsored by Akorn Access, Inc & KM9P
|