In a message dated 96-09-09 01:36:35 EDT, you write:
>When I asked you Saturday about whether the gauge would fit my guy lines, I
>gave you the wrong info. My 120' of Rohn 55 is guyed w/ the Phillystran
>equivalent of 5/16" ehs cable & the bottom 20' or so of each guy ends in
>5/16" ehs guy cable. I realize that is just 1/32" bigger than what you said
>the max was for using your gauge (9/32"), but I wonder if it'd at least
allow
>me to "ballpark" the tension w/o going to the effort & expense of trying to
>find one of the professional gauges you mentioned?
>
Hi, Mike --
LOOS has just introduced a new tensioner called a "Pro Model" that'll do
guy wire up to 3/8 inch; sounds like it's just what you need. Tower Tech
price is $129.00 and it's even easier to use than the smaller version. Using
the Model 90 (the one you looked at) to measure the slightly bigger guy wire
probably won't work because the channel that you hook onto the guy wire to
make the measurement may not take the bigger size wire.
You want to measure the tension from the EHS, not the Phillystran. The
figure from the LOOS has not been derived for direct Phillystran measurement.
BTW, I can rent one of the 0-10,000 pound Dillon tension dynamometer
locally for about $50.00 per day. You also need a cable grip and comealong
to take a reading and do your adjustments. Also figure about 15 minutes per
measurement. The LOOS instruments can give you a pretty accurate reading in
about 10 seconds.
Thanks for the kind words; glad you enjoyed the presentation.
73, Steve K7LXC
TOWER TECH -- professional tower supplies and services for amateurs
|