In a message dated 96-08-04 15:28:29 EDT, you write:
<< It's just a faint memory, but "once upon a time" I think I was tolod that
there were two (2) versions of Rohn ("pipe") top section, one with and one
without spacing to allow a HAM IV (or HAM M) to slip in and onto the rotor
plate. The TailTwister wonuld NOT fit either one. >>
Hi, Joe --
Actually Rohn makes 5 tapered top sections: 25AG1 thru 5. They have
different sized pipes on them as well a couple of different section heights.
There are a couple that have very short legs but with the ability to locate
the AS25G accessory/rotator shelf anywhere in a 25G tower, rotator location
and installation using any of the tapered top sections shouldn't be a
problem.
73 and tnx for your comments, Steve K7LXC
TOWER TECH -- professional tower supplies and services for amateurs
|