Richard Thorne - WB5M wrote:
>
> Thanks to KB2NY, KI6VY, and N1SR for the info that I needed on the
> dimensions for the base plate. I'll get completed this week.
>
> Lucky for me theres a guy at work with all the necessary machine tools,
> lathe, welding equipment and more importantly knowledge of how to do
> it correctly so it will be a safe installation.
>
> Just for FYI:
>
> - The plate is 24" square and is 5/16" thick. Rohn uses 1/4"
> plate.
> - I'll be using solid tube stock for the stubs.
>
> I believe this will be more than adequate for the installation.
>
> I'm hoping to have the tower up by the end of September.
>
> 73 and thanks again.
I'm resending this note. If its a duplicate I appologize. When I sent
this originally the power went out and I was sure if it made it to the
reflector.
73
|