I agree Rick.. Too “clever” but just enough to fool me.. once.
After I get the new coil ready (Using brass hardware to replace the stainless
bolts also) and find the sweet spot again using the proper coil clips, I will
SOLDER the clips onto the copper at that time without shorting out any other
coil turns.
Since this is a series coil at the base, I will use a shunt coil to match the
swr.. I hope that is what I am going to do and not blow up something else .
From: Richard (Rick) Karlquist
Sent: Monday, November 16, 2020 10:02 AM
To: Tim Shoppa; Larry-k1uo
Cc: topband@contesting.com
Subject: Re: Topband: Stainless Steel for coil taps.
I
_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector
|