Mike ,
I think that WD-1 is 150 ohm someone on here posted that.
So I am now looking over your.....Chart of turns ratios paper..trying to
understand it.
I maybe in over my head on this stuff...not real sure how to read the chart.
I'll have to do some more reading.
Thanks
Fred KB4QZH
On 5/9/2020 7:34 PM, Mike Waters wrote:
Fred, those transformers are the wrong impedance ratio for WD1! They are
for 420-450 ohm wire. WD-1 has a much lower impedance.
73, Mike
W0BTU
On Sat, May 9, 2020, 5:49 PM Fred Moeves <fmoeves@twc.com> wrote:
Thanks to everyone with some very good advice and good ideas
I am now looking for a good place to buy the WD1-TT.
...
Also I have wound (2) 6.25:1 transformers and (1) 1:1 reflection
transformer using the info from Mike’s (W0BTU) site.
I assume these transformers will work with any of the 2 wire Beverages
that's been discussed here in previous posts.
_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector
_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector
|