A review that was originally published in the Caribbean Contesting
Consortium Newsletter by W8WTS in September 2014. Comparison: DEO RG-2000M
and DXE RG-5000 Receiver Protectors is worth a read. Lots of good info.
http://www.k8nd.com/Radio/CW_Skimmer/W8WTS_Comparison_RG-2000_RG-5000.pdf
-----Original Message-----
From: Topband [mailto:topband-bounces+samjos=epix.net@contesting.com] On
Behalf Of Mike Waters
Sent: Friday, January 17, 2020 3:45 PM
To: topband@contesting.com
Subject: Re: Topband: Connecting Rx antenna to FTDX101
Good answer, Lloyd.
One thing I did is put a small incandescent pilot lamp in series with my
Beverages and my IC-765 transceiver's RX antenna input. The lamp functions
as a current limiter and a fuse. After the lamp, there are back-to-back
diodes to ground, which limit the maximum voltage in either polarity.
I learned this from W8JI. I used a 6.3 volt #47 lamp, but what Tom used
drew less current at its rated voltage than my #47. He could even see it
glow faintly from all the RF that his wideband Beverages were picking up.
That lamp has never blown, but it gives me peace of mind knowing that it is
helping to protect the front end from excessive RF or voltage pulses.
73, Mike
W0BTU
On Fri, Jan 17, 2020, 9:49 AM Lloyd - N9LB <lloydberg@tds.net> wrote:
> That is too much RF power for a receiver input.
> "Front End Protectors" are available for this exact problem:
>
> Array Solutions:
> https://www.arraysolutions.com/as-rxfep
>
> DX Engineering:
> https://www.dxengineering.com/parts/dxe-rg5000hd
>
> Miroslaw Paczocha wrote:
>
> I intend to connect a K9AY antenna to socket 3 of an FTDX101D, this socket
> being menu configured as Rx input. The problem is I measured about 1,5 V
on
> the K9AY coax loaded with 50 ohms with 100W forwarded to the Tx antenna
...
>
_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector
_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector
|