Topband
[Top] [All Lists]

Re: Topband: Drones for antenna installation?

To: Topband@contesting.com
Subject: Re: Topband: Drones for antenna installation?
From: "Gary Smith" <Gary@ka1j.com>
Reply-to: Gary@ka1j.com
Date: Sun, 01 Sep 2019 12:24:29 -0400
List-post: <mailto:topband@contesting.com>
Grant is exactly right about the cold & 
knocking it around. Last winter I was out 
in freezing weather and bumped the end 
into a rock. The PVC broke in the valve 
where the PVC is threaded in. I had to 
dremel two opposing slots in the broken 
piece and wedge a solid piece of metal in 
so I could unscrew it.

Just like one should not hunt with a shell 
ready to fire, one should not walk with 
pressure in the spud gun. I only 
pressurize when I am ready to launch the 
spud.

73,
Gary
KA1J

> I stick to max 80psi which has a good safety factor vs the pipe rating
> (4" @220psi in my launcher).  Very cold weather and knocking it around
> when brittle or anytime is certainly to be avoided.  An alternative is
> to buy schedule 80, McMaster sells sch 80 PVC in 5 foot lengths. The
> pressure rating for 3" is 370psi and 4" 320psi.  Then the end fittings
> should also be sch 80.
> 
> A friend once (young = stupid) made a firecracker out PVC pipe.  Note
> that PVC doesn't show on xrays, so small bits were still erupting from
> his skin 20 years later.  Fortunately no eye damage.
> 
> Grant KZ1W
> 
> _________________
> Searchable Archives: http://www.contesting.com/_topband - Topband
> Reflector
> 



_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector

<Prev in Thread] Current Thread [Next in Thread>