Hi I have decided to put up a 40m tower to use as a transmitting vertical for
1.8mHz out away from in between our other towers and where I can run 1/4 wave
radials all the way around, and will probably use locally available 12" steel
sections with a conical-type pin base. I would like to insulate the base in
order to make it easier to detune on receive (this will be located in the exact
center of our 8 circle rx arrays). Has anyone used HDPE or similar to make a
homebrew base insulator for a tower monopole? Any other comments about the need
for a base insulator also welcome.
73 Bob HS0ZIA
Sent from Yahoo Mail on Android
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
|