You are not sending your section is the error - or at least the log file
doesnt know to add this. It should be N7WS 599 ( your section) AI7H 599 ID
and so on. I had a similar problem with another contest but I am not
familiar with your logging software so nit sure of a fix but you could run
a find and replace in Notepad searching 'N7WS 599' and replacing with 'N7WS
599 (your section)' and resubmit.
Hope that helps
Paul
On Tue, 6 Dec 2016 at 23:00, Wes Stewart <wes_n7ws@triconet.org> wrote:
> I operated some S&P during the ARRL contest. I'm not a contest op but
> wanted to
> give the guys I worked some points, so I tried submitting a check log.
>
> I use DXBase for my logging program so I created an .adif file of the QSOs
> and
> used ADIF2CABR V.3.10 (C) SP7DQR to make a Cabrillo file.
>
> When I submitted I saw in part this:
>
> *ERROR-->*Following QSO errors were found:
>
> * Sent exchange is missing sec for each QSO
>
> *WARNING-->*Following QSOs were missing required exchange info. You may
> want to
> correct these when you resubmit your log.
>
> * QSO: 1814 CW 2016-12-03 0611 N7WS 599 AA5B 599 NM
> copied exchange (sec) is missing
> * QSO: 1805 CW 2016-12-03 0231 N7WS 599 AC0W 599 MN
> copied exchange (sec) is missing
> * QSO: 1815 CW 2016-12-04 1454 N7WS 599 AC7A 599 AZ
> copied exchange (sec) is missing
> * QSO: 1808 CW 2016-12-04 1307 N7WS 599 AI7H 599 ID
>
> and so on and so forth.
>
> So what's the problem?
>
> Wes N7WS
>
> _________________
> Topband Reflector Archives - http://www.contesting.com/_topband
>
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
|